Husqvarna 326HD60 ユーザーズマニュアル

English – 

17

Below you will find some general maintenance instructions.

• Check throttle trigger and throttle trigger lockout function.
• Check stop switch function.
• Check that the blades do not rotate while idling or when the

choke is in the start position.

• Clean the exterior of the machine.
• Check that the harness is undamaged.
• Check the blade guard for damage or cracks.
• Change the guard in case of impacts or cracks.
• Check that the blade is properly centred, sharp, and without

cracks.

• Check the hand guard for cracks and chips or damage.

Replace if necessary.

• Check that the blade screws are sufficiently tightened.
• Make sure that the blade transport guard is undamaged and

that it can be securely fitted.

• Check that nuts and screws are sufficiently tightened.
• Check for fuel leaks.

• Check the starter, especially cord and return spring.
• Make sure that the vibration damping elements are not

damaged.

• Clean the carburetor area.
• Clean the exterior of the spark plug.
• Remove it and check the electrode gap.
• Adjust it to 0,5 mm (.020"), or change the spark plug.
• Clean the cooling fins on the cylinder and check that the air

intake at the starter is not clogged.

• Fill the gearbox with grease. This should be carried out after

approximately every 20 working hours.

• Clean the air filter.
• Clean or replace the muffler’s spark arrest screen (not on

mufflers with a catalytic converter).

• Clean the fuel tank.
• Clean the exterior of the carburetor and the space around it.
• Clean the fan and the space around it.
• Check fuel hose for cracks or other damage. Change if

necessary.

• Change fuel filter in fuel tank.
• Check clutch, clutch spring and clutch drum for wear.

Change if necessary.

• Check electrical wires and connections.
• Change the spark plug.
• Change the airfilter.
• Check and clean the muffler’s spark arrest screen if necessary

(only mufflers with a catalytic converter).