Husqvarna 326RJ ユーザーズマニュアル
English
– 11
ASSEMBLY
Fitting the J-handle
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
handle must be fitted between the arrows on the shaft.
•
Slide the spacer into the slot in the loop handle.
•
Fit the nut, knob and screw. Do not overtighten.
•
Attach the J-handle to the loop handle using the three
screws, as shown.
screws, as shown.
•
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
position. Tighten the bolt/knob.
Assembling the cutting equipment
Fitting a trimmer guard and
Superauto II 1" trimmer head
Superauto II 1" trimmer head
•
Fit the correct trimmer guard (A) for use with the trimmer
head. Hook the guard onto the fitting on the shaft and
secure it with the bolt (L).
head. Hook the guard onto the fitting on the shaft and
secure it with the bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
To fit the trimmer head, first separate the two halves (see
diagram). Proceed as follows:
diagram). Proceed as follows:
!
WARNING! Only grass blades/grass cutters
or trimmer heads/plastic blades may be used
when the J-handle is fitted. Saw blades must
never be used with the J-handle.
or trimmer heads/plastic blades may be used
when the J-handle is fitted. Saw blades must
never be used with the J-handle.
!
WARNING! When fitting the cutting
attachment it is extremely important that the
raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is fitted incorrectly it can result
in serious and/or fatal personal injury.
attachment it is extremely important that the
raised section on the drive disc/support
flange engages correctly in the centre hole
of the cutting attachment. If the cutting
attachment is fitted incorrectly it can result
in serious and/or fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
the machine must be equipped with the correct handlebar,
blade guard and harness.
G
F
I
A
B
C
K
J
I
K