Husqvarna 325L ユーザーズマニュアル

– English

ASSEMBLY

Assembly of the trimmer head

WARNING!
Under no circumstances may the cutting
equipment be used without an approved
guard fitted. See the chapter

“Technical

data”

. If the wrong guard or a defective

guard is fitted this can cause serious
personal injury.

Assembling the loop handlebar
(322L, 325L-X/L-XT)

Assembling the loop handlebar
(322C, 325CX)

• Clip the loop handle onto

the shaft. Note that the
loop handle must be
fitted between the arrows
on the shaft.

• Slide the spacer into the

slot in the loop handle.

• 322L: Fit the nut, washer

and bolt.
325L-X/L-XT: Fit the
nut, knob and bolt. Do
not overtighten.

• Now adjust the trimmer

to give a comfortable
working position. Tighten
the bolt/knob.

• Position the handle on

the shaft. Note that the
handle must be mounted
below the arrow on the
shaft.

• Fit the bolt, securing plate

and wing nut as shown in
the diagram.

• Tighten the wing nut.

It is extremely important
that the disc drive’s/support
flange’s guide engages
correctly in the cutting
equipment’s centre hole
when assembling the cutting
equipment. Cutting
equipment assembled
incorrectly can result in
serious and/or fatal personal
injury.

Assembling and dismantling the
two-part shaft (325L-XT)

Assembling:

• Make sure the handle is

loose.

• Guide the cut-out on the

lower section of the shaft
into the coupling‘s
locking plate on the
upper section of the
shaft. The sections are
then locked together.

• Tighten the handle.

Dismantling

• Undo the handle (at least

three turns).

• Press the handle towards

the coupling.

• Carefully twist the lower

section out of the lock.

• Hold both parts of the

shaft and pull out the
lower section from the
coupling.