Husqvarna 335RX-Series ユーザーズマニュアル

14 – 

English

•

When loosening and tightening the saw blade nut, there is 
a risk of injury from the teeth of the saw blade. You should 
therefore always ensure that your hand is shielded by the 
blade guard when doing this. Always use a socket 
spanner with a shaft that is long enough to allow this. The 
arrow in the diagram shows the area where you should 
operate the socket spanner when loosening or tightening 
the nut.

•

Fit the trimmer guard/combination guard (A) intended for 
use with the trimmer head/plastic blades. CAUTION!  
Ensure that the guard extension is fitted.

Hang the trimmer guard/combination guard (A) on the two 
hooks on the plate holder (M). Bend the guard around the 
shaft and tighten it with the bolt (L) on the opposite side of 
the shaft. Use the locking pin (C). Place the locking pin in 
the groove on the screw head and tighten. See diagram.

•

Fit the drive disc (B) on the output shaft. 

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse order.

At the front is an easily accessible, quick release. Use this if 
the engine catches fire or in any other emergency situation 
that requires you to free yourself from the machine and 
harness.

A well-adjusted harness and machine makes work much 
easier. Adjust the harness for the best working position. 
Tension the side straps so that the weight is evenly distributed 
across both shoulders.

1

The machine should be supported in a harness when forestry 
clearing so that the cutting equipment is angled slightly 
forwards in relation to the ground. Adjust the height using the 
strap on the harness for the support hook.