Husqvarna 326ES ユーザーズマニュアル

English

 –

 25

1151020-95   Rev. 2   2008-03-10

Inside the hollow drive shaft of the edger is a flexible drive 
shaft. This flexible drive shaft should be regularly 
lubricated every 25 hours in operation. Loosen the two 
screws on the angle gear and remove it. The flexible drive 
shaft is easily removed from the hollow shaft by taking a 
firm grip on the shaft end. Lubricate the entire length of 
the flexible drive shaft and reinsert it in the hollow drive 
shaft. Turn the shaft while inserting it so that it correctly 
engages in the clutch. Refit the angle gear on the hollow 
drive shaft and tighten the two screws.

The cutting depth must be adjusted before starting work.

•

Loosen the locking knob (A) and rotate the guard by 
moving the locking knob forwards or backwards. If the 
locking knob is moved forwards (away from the 
machine) the cutting depth is increased. If the locking 
knob is moved backwards (towards the machine) the 
cutting depth is reduced.

•

Set the desired cutting depth.

•

Lock the locking knob.

The cutting depth must be adjusted before starting work.

•

Loosen the wing nut.

•

Set the desired cutting depth.

•

Tighten the wing nut.

CAUTION! Use only HUSQVARNA replacement parts. 
Use of other brands of replacement parts can cause 
damage to your unit or injury to the operator or others. 
Your warranty does not cover damage or liability caused 
by the use of accessories and/or attachments not 
specifically recommended by HUSQVARNA.