Husqvarna 252RX ユーザーズマニュアル
English
– 17
ASSEMBLY
Fitting the handlebar
(265RX)
•
Fit the left handlebar in the handlebar mounting.
•
Fit the right handle to the handlebar.
•
Adjust roughly and tighten the screws slightly.
•
Now make a final adjustment, with the machine hanging
from the harness, to obtain the most comfortable working
position. Tighten the screws.
from the harness, to obtain the most comfortable working
position. Tighten the screws.
•
Make the final adjustment to the right handle and lock it in
the most comfortable position.
the most comfortable position.
Adjusting the throttle trigger
The throttle trigger can be adjusted to give the best working
position. This is done using the Allen screws by the right
handle.
position. This is done using the Allen screws by the right
handle.
Assembling the cutting equipment
Fitting a blade guard, grass blade
and grass cutter
and grass cutter
•
The blade guard (A) is fitted using 4 screws (L) and the
support plate (M) as shown.
support plate (M) as shown.
CAUTION! Always use the recommended guard for the
cutting attachment you are using. See chapter on
Technical data.
cutting attachment you are using. See chapter on
Technical data.
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Place the blade (D) on the output shaft.
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
the machine must be equipped with the correct handlebar,
blade guard and harness.
M
E
N
F
D
B
C
A
L