Husqvarna 252RX ユーザーズマニュアル

ページ / 45
English
 – 23
STARTING AND STOPPING
Check before starting
Never start the machine indoors. Exhaust fumes can be 
dangerous if inhaled.
Observe your surroundings and make sure that there is no 
risk of people or animals coming into contact with the 
cutting equipment.
Place the machine on the ground, ensure the cutting 
attachment is clear of twigs and stones. Hold the body of 
the machine on the ground using your left hand 
(CAUTION! Not with your foot). Then grip the starter 
handle with your right hand and pull the starter cord. 
For safety reasons follow these recommendations!
Check the blade to ensure that no cracks have formed at 
the bottom of the teeth or by the centre hole. The most 
common reason why cracks are formed is that sharp 
corners have been formed at the bottom of the teeth while 
sharpening or that the blade has been used with dull 
teeth. Discard a blade if cracks are found.
Check that the support flange is not cracked due to fatigue 
or due to being tightened too much. Discard the support 
flange if it is cracked.
Ensure the locking nut has not lost its captive force. The 
nut lock should have a locking force of at least 1.5 Nm. 
The tightening torque of the locking nut should be 35-50 
Nm.
Check that the blade guard is not damaged or cracked. 
Replace the blade guard if it is exposed to impact or is 
cracked.
Check that the trimmer head and trimmer guard are not 
damaged or cracked. Replace the trimmer head or 
trimmer guard if they have been exposed to impact or are 
cracked.
Never use the machine without a guard nor with a 
defective guard.
!
WARNING! When the engine is started with 
the choke in either the choke or start throttle 
positions the cutting attachment will start to 
rotate immediately.
!
WARNING! The complete clutch cover and 
shaft must be fitted before the machine is 
started, otherwise the clutch can come loose 
and cause personal injury.
Always move the machine away from the 
refuelling area before starting. Place the 
machine on a flat surface. Ensure the cutting 
attachment cannot come into contact with 
any object. 
Make sure no unauthorised persons are in 
the working area, otherwise there is a risk of 
serious personal injury. The safety distance 
is 15 metres.