Husqvarna 323RJ ユーザーズマニュアル

 

English

 

 – 11

 

•

Clip the loop handle onto the shaft. Note that the loop 
handle must be fitted between the arrows on the shaft.

•

Slide the spacer into the slot in the loop handle.

•

Fit the nut, knob and screw. Do not overtighten.

•

Attach the J-handle to the loop handle using the three 
screws, as shown.

•

Now adjust the trimmer to give a comfortable working 
position. Tighten the bolt/knob.

 

When fitting the cutting attachment it is extremely important 
that the raised section on the drive disc/support flange 
engages correctly in the centre hole of the cutting attachment. 
If the cutting attachment is fitted incorrectly it can result in 
serious and/or fatal personal injury.

 

•

Fit the correct trimmer guard (A) for use with the trimmer 
head. Hook the guard onto the fitting on the shaft and 
secure it with the bolt (L).

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

To fit the trimmer head, first separate the two halves (see 
diagram). Proceed as follows:

•

Insert a finger into the centre hole of the cover (I) while 
grasping the cover with your other fingers. Using the index 
finger and thumb of your other hand, release the two 
catches (J) that engage in the cut-outs in the bottom half 
(K). Pull apart the trimmer head, grasping the cover firmly.

•

Place the cover (I) and the support flange (F) on the 
output shaft.

•

Fit the nut (G). The nut must be tightened to a torque of 
35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool 
kit. Hold the shaft of the spanner as close to the blade 
guard as possible. To tighten the nut, turn the spanner in 
the opposite direction to the direction of rotation (Caution! 
left-hand thread). 

•

Fit the bottom half of the trimmer head (K) to the cover (I) 
by pressing them together, with the cut-outs on the bottom 
half aligned with the catches on the cover.

•

To dismantle, follow the instructions in the reverse order.