Husqvarna 123LD ユーザーズマニュアル

12 – 

English

•

Position the handle on the shaft. Note that the handle 
must be mounted below the arrow on the shaft.

•

Fit the screw, securing plate and wing nut as shown in the 
diagram.

•

Tighten the wing nut.

•

Make sure the knob is loose.

•

Align the cut-out in the lower part of the shaft with the 
coupling locking tab on the upper part of the shaft. Then 
lock the sections together.

•

Tighten the knob.

•

Undo the knob (at least three turns).

•

Push the knob towards the coupling.

•

Carefully twist the lower half of the shaft to unlock it.

•

Hold both parts of the shaft and pull the lower part of the 
shaft out of the coupling.

•

Fit the correct trimmer guard (A) for use with the trimmer 
head. 

Hook the trimmer guard/combination guard onto the fitting 
on the shaft and secure with the bolt (L).

• Fit the drive disc on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

• Insert the locking pin in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse order.