Husqvarna 123LD ユーザーズマニュアル
16 –
English
STARTING AND STOPPING
Check before starting
•
Check that the support flange is not cracked due to fatigue
or due to being tightened too much. Discard the support
flange if it is cracked.
or due to being tightened too much. Discard the support
flange if it is cracked.
•
Ensure the locking nut has not lost its captive force. The
nut lock should have a locking force of at least 1.5 Nm. The
tightening torque of the locking nut should be 35-50 Nm.
nut lock should have a locking force of at least 1.5 Nm. The
tightening torque of the locking nut should be 35-50 Nm.
•
Check that the blade guard is not damaged or cracked.
Replace the blade guard if it is exposed to impact or is
cracked.
Replace the blade guard if it is exposed to impact or is
cracked.
•
Check that the trimmer head and trimmer guard are not
damaged or cracked. Replace the trimmer head or
trimmer guard if they have been exposed to impact or are
cracked.
damaged or cracked. Replace the trimmer head or
trimmer guard if they have been exposed to impact or are
cracked.
•
Never use the machine without a guard nor with a
defective guard.
defective guard.
Starting and stopping
Cold engine
Ignition:
Set the stop switch to the start position.
Choke: Set the choke control in the choke position.
Air purge: Press the air purge diaphragm repeatedly until fuel
begins to fill the diaphragm. The diaphragm need not be
completely filled.
begins to fill the diaphragm. The diaphragm need not be
completely filled.
!
WARNING! The complete clutch cover and
shaft must be fitted before the machine is
started, otherwise the clutch can come loose
and cause personal injury.
shaft must be fitted before the machine is
started, otherwise the clutch can come loose
and cause personal injury.
Always move the machine away from the
refuelling area before starting. Place the
machine on a flat surface. Ensure the cutting
attachment cannot come into contact with
any object.
refuelling area before starting. Place the
machine on a flat surface. Ensure the cutting
attachment cannot come into contact with
any object.
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
serious personal injury. The safety distance
is 15 metres.
the working area, otherwise there is a risk of
serious personal injury. The safety distance
is 15 metres.