Husqvarna 232R ユーザーズマニュアル

English

 – 17

Hang the trimmer guard/combination guard (A) on the two 
hooks on the plate holder (M). Bend the guard around the 
shaft and tighten it with the bolt (L) on the opposite side of 
the shaft. Use the locking pin (C). Place the locking pin in 
the groove on the screw head and tighten. See diagram.

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse order.

At the front is an easily accessible, quick release. Use this if 
the engine catches fire or in any other emergency situation 
that requires you to free yourself from the machine and 
harness.

A well-adjusted harness and machine makes work much 
easier. Adjust the harness for the best working position. 
Tension the side straps so that the weight is evenly distributed 
across both shoulders.

1

Adjust the support strap so that the support hook is 
around 10 cm below your hip. The blade should be angled 
forward a little.

2

The support hook should hang around 20 cm below your 
hip so that the blade is parallel to the ground.

1

Move the suspension ring on the machine forward or 
backward. It is easier to avoid sawing into the ground if the 
blade is balanced a few dm above the ground.

2

Let the blade balance at a comfortable cutting height, i.e. 
close to the ground.