HP (Hewlett-Packard) 8360 ユーザーズマニュアル

 Sweep

MARKER

This 

 lets you set the synthesizer to start sweeping at the

frequency of marker 1 (Ml), and stop sweeping at the frequency of
marker 2 

 

 must have a higher frequency value than Ml. If

is activated when 

 is at a lower frequency than

Ml, the values of Ml and 

 are permanently interchanged. While

this function is active, the start/stop frequencies of the synthesizer
are changed to the values of Ml and 

 An asterisk next to the key

label indicates this feature is active.

SCPI: 

SWEep:MARKer:STATe 

Analyzer: 

 function on, MPO function off.

“Marker Operation,” in Chapter 1.
“Programming Typical Measurements,” in Chapter 1.

Manual Sweep

SWEEP

This 

 lets you set the synthesizer to the manual sweep mode

of operation. Depending on what parameter is sweeping, you can
use either the rotary knob or the ARROW keys to manually sweep
between the start/stop limits. In manual sweep mode, the synthesizer
does not automatically retrace at the sweep end point (the user must
turn the rotary knob to retrace), and the green SWEEP LED does
not light. The resolution of the rotary knob is 0.1% of the sweep
span in either start/stop or 

 mode. The resolution of the

 and 

 arrow keys are dependent on the resolution defined by