Chicago Electric 68853 ユーザーズマニュアル

Page 8

Item 68853 

        

WARNING!  Do not install the Battery Pack 

until 

AFTER you complete the following 

steps to set up the tool for use.

WARNING! Only use 1/4" Hex Shank bits 

designed for impact use.  Verify bit fits the 

screw/hex bolt precisely before use.

1.  An additional bit may be stored in the 

Driver’s Bit Groove during use.

2.  To lock the trigger mechanism as a safety 

measure, slide the Direction Switch so that 

it is in the center position.  This will prevent 

the driver turning on accidentally.

3.  Pull Collar (11-1) forward, insert bit into Anvil and 

then release Collar.  Pull on bit to ensure it is secure. 

4.  Insert the fully charged Battery Pack into the base of 

the Impact Driver, making sure that it clicks into place 

securely. Be sure the Battery Pack is securely seated 

into the Handle so it does not fall off during use.

while Anvil is rotating.  Wait until Anvil has come 

to a complete stop before changing direction.

1.  Place the Battery Pack on a dry fireproof surface in 

a room where the temperature is from 50–104° F.

Note: If recharging a newly spent Battery Pack, 

allow it to cool completely before charging.
2.  Examine the Battery Pack.  It must be 

undamaged, and a NiCd type Battery Pack.

3.  The Battery Pack’s terminals are designed to fit 

this Charger specifically.  If the Battery Pack does 

to not fit the Charger properly, do not try to insert it.  

4.  Plug the Power Supply into a grounded, 

120V~, 60Hz receptacle.

5.  Connect the Power Supply to the Charger.  

The 

green power LED will light, showing 

that power is supplied to the Charger.

6.  Slide the Battery Pack into the charger until the 

button on the Battery Pack clicks into place.  

The Red LED will flash to show the Battery is 

charging and the Green LED will continue to stay lit.

Note: The Battery Pack’s capacity will increase 

somewhat during the first few charging cycles. 

A fully discharged Battery Pack will take about 1 hour 

to fully charge. 

 Recharging the Battery Pack for 

more than 1 hour can damage the battery cells. 
7.  While charging, the Battery Pack, Charger, and 

Power Supply may become warm to the touch. 

This is normal, and does not indicate a problem.

8.  The red LED will light continuously when the 

Battery Pack is charged. Unplug the Charger and 

disconnect it from the Battery Pack when finished.

9.  Allow the Battery Pack to cool 

completely before using it.

10. Press the Battery Button to release 

Battery Pack from the Charger.