Multiquip LT6D ユーザーズマニュアル

1.  Place the main circuit breaker, CB1 (Figure 18) on the 

control panel to the 

On position.

2.  Place circuit breaker, CB2 (Figure 19) on the control 

panel to the 

On position. This will turn on the top 2 

lights.

3.  Next, place circuit breaker, CB3 (Figure 19) on the 

control panel to the 

On position. This will turn on the 

bottom 2 lights.

4.  Wait a few minutes for the ballasts to activate. Observe 

that all lights are 

On.

5.  If all the light circuit breakers (CB2 and CB3) are in the 

On position (up), then all of the lights should be on.

6.  If any of the lights are not on, refer to the troubleshooting 

section of this manual.

7.  Close all cabinet doors.

CB1

CB2

CB3

neveR operate the light tower with the engine 

compartment doors open. Operation with the doors 

open may cause insufficient cooling to the unit, and 

damage may result.

1.  Open the access panel door on the 

fuel side of the 

light tower. Set the door latch in place to hold the door 

open (up).

2.  Insert the ignition key into the ignition key switch 

(Figure 17). Turn the ignition key clockwise one click 

to the 

On position. The preheat indicator lamp will 

light. Wait for this indicator lamp to go 

OFF. When the 

indicator lamp goes

 OFF, the glow plugs have been 

preheated and the engine can now be started.

3.  Continue turning the ignition key all the way clockwise 

When the engine has started, release the key.

4.  Before placing the light tower into actual operation, let 

the engine run for 3-5 minutes. Check any abnormal 

sounds or smells that would be associated with a 

defective light tower. If any abnormal conditions occur, 

shut down the engine and correct the problem.

neveR start the engine with any circuit breakers in 

the 

On position. Disconnect all loads before starting.

neveR place hands near the V-belt or fan 

blades while the engine is running.

The engine's exhaust contains harmful 

emissions. 

ALWAYS ventilate the exhaust 

when operating inside tunnels, excavations 

or buildings. Direct exhaust away from 

nearby personnel.

IGNITION

SWITCH

PREHEAT

LED INDICATOR