Grizzly G4173 1 8 HP ユーザーズマニュアル
Model g4173
1
⁄
8
hp power Feeder
-13-
the unpainted surfaces are coated with a waxy
oil to prevent corrosion during shipment. remove
this protective coating with a solvent cleaner or
degreaser, such as shown in
oil to prevent corrosion during shipment. remove
this protective coating with a solvent cleaner or
degreaser, such as shown in
Figure 5. For thor-
ough cleaning, some parts must be removed.
For optimum performance, clean all moving
parts or sliding contact surfaces. avoid chlo-
rine-based solvents, such as acetone or brake
parts cleaner that may damage painted surfac-
es. always follow the manufacturer’s instructions
when using any type of cleaning product.
rine-based solvents, such as acetone or brake
parts cleaner that may damage painted surfac-
es. always follow the manufacturer’s instructions
when using any type of cleaning product.
clean up
Gasoline and petroleum
products have low flash
points and can explode
or cause fire if used to
clean machinery. DO
NOt use these products
to clean the machinery.
Many cleaning solvents
are toxic if inhaled.
Minimize your risk by only
using these products in a
well ventilated area.
G2544—Solvent cleaner & Degreaser
a great product for removing the waxy shipping
grease from your machine during clean up.
a great product for removing the waxy shipping
grease from your machine during clean up.
Figure 5. Cleaner/degreaser available from
grizzly.
assembly
to correctly position this power feeder on your
table top, completely assemble the power feeder
first, then refer to Base Mounting on page 17.
With the power feeder unit completely assembled,
it will be easier to locate where on the table top
you will need to drill your base mounting holes, so
you can take advantage of the full range of power
feeder swing and adjustments.
table top, completely assemble the power feeder
first, then refer to Base Mounting on page 17.
With the power feeder unit completely assembled,
it will be easier to locate where on the table top
you will need to drill your base mounting holes, so
you can take advantage of the full range of power
feeder swing and adjustments.
to assemble the power feeder:
1. oil the t-handle threads and position the
elbow clamp assembly onto the feeder base
as shown in
as shown in
Figure 6.
2. thread the t-handle into the feeder base
until the elbow is snug.
3. insert the arm into the ball-joint ball and
secure both together with the M10-1.5 x
25mm cap screw shown in
25mm cap screw shown in
Figure 7.
4. insert the ball joint assembly into the power
feed socket shown in
Figure 7.
Figure 6. assembled elbow clamp assembly.
Elbow
Clamp
Feeder
Base
t-handle