Maytag W10600814B ユーザーズマニュアル

■

Has a household fuse blown, or has a circuit breaker 
tripped?
Replace the fuse or reset the circuit breaker. If the problem 
continues, call an electrician.

■

Is the cooktop control set correctly?
Touch the display area on the control panel to select a 
cooking surface before selecting a function.

■

On ceramic glass models, is the oven control lockout set?
See “Control Lockout” section.

■

Has the cooktop turned off by itself?
The Power key was unintentionally touched. Press POWER 
again. Reset the cooktop.

■

Is the cookware the proper size?
Use cookware about the same size as the surface cooking 
area, element or surface burner. Cookware should not extend 
more than ½" (1.3 cm) outside the cooking area.

■

Does the Hot Surface indicator light stay on after control 
knob(s) have been turned off?
See “Cooktop Controls” section.

■

Is the proper cookware being used?
See “Cookware” section.

■

Is the cooktop control set to the proper heat level?
See “Cooktop Controls” section.

■

Is the range level?
Level the range. See the Installation Instructions.

■

Is the electronic oven control set correctly?
See “Electronic Oven Controls” section.

■

Has a delay start been set?
See “Timed/Delay Cooking” section.

■

On some models, is the oven control lockout set?
See “Control Lockout” section.

■

On some models, is the Sabbath Mode set?
See the “Sabbath Mode” section.

■

Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.

■

Do the oven indicator lights flash?
See the “Display” and/or the “Oven Lights” section. If the 
indicator light(s) keeps flashing, call for service. See 
“Assistance or Service” section.

■

Have the tones been deactivated?
See “Tones” in the “Settings” section.

■

Is the oven display showing “12:00”?
There has been a power failure. Clear the display. See 
“Display” section. On some models, reset the clock, if 
needed. See the “Clock” section.

■

Is the oven display showing a letter followed by a 
number?
Press any CANCEL to clear the display. See “Display” in the 
“Electronic Oven Controls” section. If it reappears, call for 
service. See “Assistance or Service” section.

■

Is the display flashing the “replace pan” animation when 
you place a saucepan on an induction surface cooking 
area? 
See “Pan Detection” in the “Cooktop Controls” section. 
Check that the saucepan is ferromagnetic. Check that the 
diameter of the saucepan is large enough. Center the 
saucepan on the surface cooking area. Allow the saucepan to 
cool down in the event that it has become hot when used. 
Switch the surface cooking area off, then on again. If the 
display still does not light up, turn power off at the circuit 
breaker. Wait 20 seconds and turn power back on.

■

Is the cooking time longer than expected, or is the 
Performance Boost function display flashing and 
switching off? 
The Performance Boost function operates the surface 
cooking area with the most power. During long cooking times, 
it is possible that the function will switch the surface cooking 
area off to keep the cooktop from overheating. You can 
continue to use the cooktop if the display is not flashing.

■

Is the display flashing “Er” and numbers? 
If an “Er” and a series of numbers appear in the display panel, 
turn power off at the circuit breaker. Turn on again. If problem 
continues, call customer service. See “Assistance or Service” 
section.