KitchenAid W10596243B ユーザーズマニュアル

ページ / 64
16
Dishwasher Maintenance Procedure       
Vacation or Extended Time Without Use   
Troubleshooting
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
In the U.S.A., www.kitchenaid.com     In Canada, www.kitchenaid.ca
Cleaning the Dishwasher 
Clean the exterior of dishwasher with a soft, damp cloth and mild detergent. If your dishwasher has a stainless steel exterior, a stainless 
steel cleaner is recommended - Stainless Steel Cleaner and Polish Part Number 31462A.
Removal of Hard Water / Filming: 
Recommended use of a monthly maintenance product such as affresh
®
 Dishwasher Cleaner Part Number W10282479. 
Load your dishwasher (preferably with dishes affected by filming / hard water).
Place tablet in main wash compartment of detergent dispenser.
Select cycle/option best for heavily soiled dishes and start dishwasher.
NOTE: Recommended to use a premeasured detergent tablet or pack for regular daily use.
To reduce the risk of property 
damage
If you will not be using the dishwasher during the summer months, turn off the water 
and power supply to the dishwasher.
Make sure the water supply lines are protected against freezing conditions. Ice 
formations in the supply lines can increase water pressure and damage your 
dishwasher or home. Damage from freezing is not covered by the warranty.
When storing your dishwasher in the winter, avoid water damage by having your 
dishwasher winterized by authorized service personnel. 
® affresh is a registered trademark of Whirlpool, U.S.A.
PROBLEM
SOLUTION
DISHWASHER DOES 
NOT RUN
NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
If the Start/Resume light is blinking, close the door and push START/RESUME.
Be sure the door is closed and latched. 
Be sure you have disabled Sleep Mode by pressing either START/RESUME or CANCEL, or opening and 
closing the door before selecting your cycle/option.
Check that there is not an interference with large casserole dishes and the wash system at the back of 
the dishwasher. Adjust loading as necessary to ensure door is closed and latched.
Be sure you have selected a cycle. (See “Cycle and Option Descriptions” section.)
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start/Resume blink and the unit will not run, you will need to call for service. 
DETERGENT REMAINS IN 
THE DISPENSER OR
TABLET IS ON BOTTOM 
OF TUB
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may be 
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
Be sure the cycle has completed (the Clean light is on). If it has not completed, you will need to resume 
the cycle by closing the door and pressing START/RESUME.
CYCLE RUNS TOO LONG
NOTES: 
To use less water and reduce energy consumption you will encounter cycles that typically run for up 
to 3 hours. 
A water heater setting of 120°F (49°C) is best, the dishwasher will delay longer while heating cooler 
water.
Some options will add time to the cycle. (See “Cycle and Option Descriptions” section.) The 
ProDry™ or Heat Dry option adds approximately 
¹⁄₂ hour.
Try the 1 Hour Wash cycle.
Run the hot water at a faucet close to the dishwasher before starting the cycle.