Electrolux WT65H208DU ユーザーズマニュアル

17

or scrapers; rinse thoroughly using a wet cloth and care-
fully wipe dry.  Clean the control panel using a soft damp 
cloth and a neutral detergent if necessary.

Do not wash the appliance using direct or high-pressure 
water jets.  To reduce the emission of pollutants into the 
environment, clean the appliance (externally and where 
necessary internally) with products having a biodegrada-
bility of over 90%.

Leave the hood raised whenever the appliance is not in 
use.

WARNING: DELIMING SOLUTION, RINSE AGENTS 
OR ANY OTHER KIND OF ACID MUST NOT COME IN 
CONTACT WITH BLEACH OR RINSE SOLUTION 
CONTAINING BLEACH USED IN CHEMICAL-SANITI-
ZING MACHINES. MIXING MAY CAUSE HAZARDOUS 
GAS TO FORM. THIS ENTIRE PROCEDURE MUST 
BE FOLLOWED STEP BY STEP FOR SAFE AND SATI-
SFACTORY RESULTS.

DELIME THE DISHWASHER ON A REGULAR BASIS 
AS REQUIRED. The regurarity will depend on mineral 
content of the supply water. Deliming should be done 
when you can see clear signs of lime deposits (a white, 
chalky substance) on the inside walls and on the wash 
arms. If deliming is necessary, a deliming agent should 
be used for best results.

Raise the hood and remove any baskets that are in 
chamber. 

Remove tank filter “C” and overflow “W”.

Close the hood and select the drain cycle by pressing 
the “B” button (Figure 13).

The message “CLE” ("CLEAN") will be displayed throu-
ghout the drain cycle. 

After a few minutes, 3 beeps indicate the end of the cle-
aning cycle and “END” blinks on the display:

At the end of drain cycle, raise the hood, replace the 
tank filter  “C”, the overflow “W” and close the hood.

Switch off the dishwasher by pressing “A” button 
(Figure 13) 

Press on/off “A” button (Figure 13). 

The indicator light of the on/off button “A” comes on, indi-
cating the dishwasher is powered and the water is being 
introduced and heated. The word “FILL” scrolls across 
display during the entire filling and heating stage. 

The filling and heating stage has finished when the 
display shows the tank temperature:

Raise the hood, pour the required amount of deliming 
agent regarding agent concentration suggested by agent 
supplier for 11 gallons/42 liters of water.

Close the hood and start the Cycle III by pressing “F” 
button (Figure 13). The wash cycle duration is 2 minu-
tes.

At the end of the cycle the dishwasher emits a series of 
beeps and “END” blinks on the display.

W

C