Multiquip GA-2.9R ユーザーズマニュアル

This section is intended to assist the
operator with the 

initial start-up of the trash generator.  It is

extremely important that this section be read carefully before
attempting to use the generator in the field.

2. Place the

 choke lever (Figure 12) in the "CLOSED " position

if starting a 

cold engine.

3. Place the

 choke lever (Figure  12) in the "OPEN " position

if starting a 

warm engine or the temperature is warm.

4. Place the

 engine ON/OFF switch (Figure 13) in the "ON "

position.

1. Place the engine 

fuel valve lever (Figure 11) to the "ON"

position.

”

DO NOT attempt to operate this
generator until the Safety, General
Information and Inspection sections
of this manual have been 

thoroughly understood.

5. Grasp the starter grip (Figure 14) and slowly pull it out. The

resistance becomes the hardest at a certain position, corre-
sponding to the compression point. Pull the starter grip briskly
and smoothly for starting.

DO NOT pull the starter rope all the way to the end.

DO NOT release the starter knob after pulling. Allow it to
rewind as soon as possible.

1. Be sure to 

disconnect all electrical loads from the

generator

  prior to starting the engine.

2. NEVER 

start  the engine with the main circuit breaker

in the “ON" position. Place the main circuit breaker
(Figure 10) in the OFF position.