Frigidaire 30 ユーザーズマニュアル

4

the unit must be secure in place. Remove the burner 
grates and burner pans. the top may then be raised 
after removing the knobs and by lifting along the 
front edge of the top. holes are provided in the front 
and rear of the burner box to secure the unit to the 
cabinet (see figure 4).

Burner Box

Wood Screw
(Not Provided)

Countertop

Cooktop

• Do not allow dry empty pans to cook on the cooktop

as this could ruin the pan and cause a fire hazard.

• Do not use a wok on the cooking surface if it is

equipped with a round metal support placed over the 
burner grate. this support acts as a heat trap which 
may damage the burner grate, spillover bows and 
burner head. it may also cause the burner to work 
improperly and create a carbon monoxide level above 
current standards resulting in a over adjacent burners.

• When lowering the cooktop be careful not to pinch

your fingers. grasp sides of the top with fingertips and 
lower into position.

these appliances and its individual shutoff valve must be 
disconnected from the gas supply piping system during 
any pressure testing of that system exceeding ½ psig.

these appliances must be isolated from the gas supply 
pipping system by closing its individual manual shutoff 
valve during any pressure testing of the gas supply piping 
system equal to or less than ½ psig.

to avoid pilot outage (if applicable) close all openings 
in the cabinet cavity that enclose this unit. Any opening 
around gas service outlets must also be closed at the 
time of installation.

 these cooktops are not approved for use 

with downdraft systems.

 Disconnect the electrical supply before 

servicing cooktops.

NOTE: if an outlet 

is not available, 

have one installed 

by a qualified 

technician.

8"

10"

22"

CL of floor

Recommended  area for 

120V grounded outlet 

on rear wall

CL of wall 

and unit

26" Models

30" Models

36" Models

Dimension A

12 ½"

12"

17 1/8"