Fisher & Paykel OR60 ユーザーズマニュアル

21

My cooktop burners do not light

Check the cooker is switched on.
Check the gas supply valve is turned on and the 
supply to the house is working. You should hear the 
gas when you turn a burner on.
The ignitors may be dirty. Clean them with a 
toothbrush and methylated spirits.
The burner parts may not be located properly. Check 
the assembly and make sure the burner cap is sitting 
flat.

My burner flames are yellow or 
hard to start

The burner parts may not be located properly. Check 
the assembly and make sure the burner cap is sitting 
flat.
If you use bottled gas this may indicate you are 
getting near the end of the bottle.
Check the burner parts are clean and dry.
The gas pressure may not be at the correct level. 
Check with your service person or installer.
Your cooker may not be set up for the gas you are 
using. Check this with your service person or installer. 

One of my burners has an uneven 
flame

Check the burner parts are clean and dry. Check the 
assembly and make sure the burner cap is sitting flat.

The flame goes out at low settings

The gas supply pressure may be low. Check this with 
your service person or installer.
The low setting may have been adjusted incorrectly. 
Check this with your service person or installer.

My burners do not turn down 
much (when running on bottled 
gas or LPG)

Your cooktop may not have been adjusted correctly. 
Check this with your service person or installer.

The flame tips are very yellow

Call your service person to service the cooker.

There are objectionable odours

Call your service person to service the cooker.

The flame appears to lift off the 
burner

Call your service person to service the cooker.

There is an electricity failure

If there is an electricity failure, you can still use your 
cooktop. Light the burners by holding a match close 
to the side of the burner and turning the control 
knob to the High position. Wait until the flame is 
burning evenly before adjusting.