Viking F20518A ユーザーズマニュアル

Open door completely. Place pin in pin hole.

Note: Two pins included.

Remove hinge trim screws. Take off hinge trim.

Close until pins stop door.

Lift door up and out.

Note: Do not lift door using handle.

NOTICE

DO NOT use the handle or oven door to

lift the oven. Remove door before

installation to ensure that it is not used to

lift the unit. DO NOT lift or carry the door

by the handle.

Removing the door must be done by your

dealer, a qualified licensed plumber, or

certified gas installer.

Installation (30”W.)

Remove wooden brace on front of pallet.

Door Removal (30”W.)

General Information

READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION WHEN
INSTALLING THIS APPLIANCE.

• All openings in the wall behind the

appliance or in the floor under the
appliance should be sealed.

• Keep appliance area clear and free from

combustible materials, gasoline and other
flammable vapors.

• Disconnect the electrical supply prior to

servicing or cleaning.

• When removing the appliance for cleaning

or service, disconnect AC power supply
and carefully remove the appliance by
pulling forward.

• Electrical requirements are listed in the

product specifications under the “Electrical
& Gas Requirements” section.

• Do not obstruct the flow of combustion and

ventilation air.

Moving, Handling, and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the outside
and inside of the ovens.

Some stainless steel parts may have a plastic
protective wrap which must be peeled off.
The interior should be washed thoroughly
with hot, soapy water to remove film
residues and any dust or debris before being
used, then rinsed and wiped dry. Solutions
stronger than soap and water are rarely
needed.

Recommendations for Unpacking
• Products are shipped on pallets with foam

footings and corrugated inner-packing and
exterior hoods.

• Products are anchored to the pallet using

metal straps that are screwed to the
bottom of the product and the pallet.

• DO NOT remove protective packaging

until you are ready to perform the
installation.

• To remove the packaging, first remove the

staples located at the bottom perimeter of
the corrugated cover.

• Remove the corrugated cover by lifting it

off the product and remove the inner-
packing.

• Detach the product from the metal anchor

strip by removing the attachment screw.

Recommendations for Moving
• The appliance is heavy – use extreme care

when handling!

• Only proper equipment should be used to

move products.

• ALWAYS take steps to protect flooring at

the installation location when moving
products.