Liebherr WS 40 ユーザーズマニュアル

EFROSTING

LEANING

Figure 19

Keep your stainless steel looking new by cleaning

with a good quality stainless steel cleaner or polish

monthly. High quality stainless steel cleaners and

conditioners are commercially available.
DO NOT CLEAN WITH STEEL WOOL PADS or

ABRASIVE PADS. DO NOT use cleaners that

are not for use on stainless steel, such as

glass cleaners, tile cleaners or cleaners used to

clean counter tops. These types of cleaners can

damage the surface permanently.
Stainless steel that is exposed to chlorine gas

and moisture may have some discoloration. This

discoloration is normal. If your unit is used in this

environment, clean and polish your stainless steel

more often.

If the surface discolors or rusting appears, clean

it quickly with a non-abrasive cloth and protect it.

Always clean and polish in the direction of the grain

and finish.

IMPORTANT

Mold can form on the bottles and labels

depending on the type of adhesive used on

the labels. This can be prevented by care-

fully cleaning any adhesive residues off the

bottles.

Defrosting

The appliance compartment defrosts automatically.

The water that forms on the rear wall drains

into a reservoir at the back of the appliance and

evaporates automatically through the compressor

heat.

Cleaning

WARNING

•

To prevent possible injury due to an

electrical shock, be sure to disconnect

the power cord or turn OFF the circuit

breaker before replacing the interior

light bulb(s) or cleaning the appliance.

•

To avoid injury or damage, DO NOT

use steam cleaning equipment to

clean the appliance.

Clean the appliance by hand with lukewarm water

and a little detergent or an all-purpose cleaner with

a neutral pH.

DO NOT use abrasive or scouring sponges. DO

NOT use concentrated cleaning agents. NEVER

use abrasive or acid cleaners or chemical solvents

or steam cleaners.

• Ensure no cleaning water penetrates into the

electrical components or ventilation grille.

• Dry all parts well with a cloth.

•

DO NOT damage or remove the model plate on

the inside of the appliance. It is very important

for servicing your appliance.

Remove any dust from the outside of the ventilation

grille

(Figure 19) with a vacuum cleaner.