Haier HBF205E ユーザーズマニュアル

STEP 5

Note:

Make sure the body of the keg coupler is in the closed (up) position

before installing it on the beer keg.

Install keg joining bracket to the first 1⁄4 barrel keg. Place one of the two keg

couplers onto the first (bottom) keg and turn clockwise to engage. To activate

push down the coupler and turn clockwise. BE SURE THAT THE HOSES ARE

OVER THE KEG JOINING BRACKET. It is normal to have some beer spray from

the keg during this process.

STEP 6

Place the second (top) keg into the top of the keg joining bracket

and tighten side screws. Place the remaining keg coupler onto the top keg and

turn clockwise to engage. To activate push down the coupler and turn clockwise.

It is normal to have some beer spray from the keg during this process.
IMPORTANT: The red and white hose of the bottom keg

should be routed over the split of the

joining bracket as shown in the picture.

Note: Be sure keg couplers are engaged completely

prior to inserting kegs in to the beer dispenser.

STEP 7

YOU MAY NOW TURN ON THE GAS AT THE TANK

AND OPEN BOTH BLACK HANDLES TO THE UP/DOWN

POSITION. With a flat head screw driver, turn screw on

top of regulator clockwise until the top gauge reads 8 PSI

STEP 8

At this time check the flow of beer by pulling each of the

taps forward. Make sure you use a container so as not to

spill the beer on the unit.

STEP 9

Remove the nut from the retainer bolt. Use two retainer fixing screws to secure

the retainer to the holes on the back of the cycliner. Then slide the cylinder

through the retainer and place it in the cabinet. Then tighten the retainer nut.

Carefully tilt the two beer kegs combination and rest the edge on the stainless

steel keg floor support on the bottom of the interior cabinet. Slide the kegs in

slowly, ensuring that it is properly located. THIS MAY REQUIRE 2 PEOPLE

TO COMPLETE.

Keg Joining Bracket

1/4 Barrel Keg

OCK

WISE

PUSH DOWN

THEN

English