Mr. Coffee ECM9 ユーザーズマニュアル
SPECIAL CORD SET INSTRUCTIONS
1.
A short power supply cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord.
entangled in or tripping over a longer cord.
2.
An extension cord may be purchased and used if care is exercised in its use.
3.
If an extension cord is used, the marked electrical rating of the extension cord must
be at least 10 amps and 120 volts. The resulting extended cord must be arranged
so that it will not drape over the counter top or table top where it can be pulled on by
children or tripped over accidentally.
children or tripped over accidentally.
l
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outbt, reverse the plug. If it still does not
reduce the risk of electric shock, this plug will fit in a polarized outlet only one
way. If the plug does not fit fully in the outbt, reverse the plug. If it still does not
fit, contact a qualified electrician. Do not attempt to modify the plug in any way.
CAUTION: PRESSURE
In order to avoid possible burns to body parts and/or other Injury from hot
steam and water NEVER open the boiler cap while your Mr. Coffee Steam
Espresso/Cappuccino Maker is turned on or as long as there is pressure In
the water tank.
In order to check if the machine is under pressure, proceed as follows:
1.
Turn the selector control knob to OFF, and unplug the machine.
2.
Rotate the selector control knob to the “steam” position. If steam comes out
of the frothing tube, then the water tank is still under pressure. Turn the
selector control knob to OFF.
selector control knob to OFF.
3. To release the pressure, hold a pitcher with water under the frothing tube
and immerse the frothing aid in the water. Slowly
4.
When the frothing tube stops releasing steam, the boiler cap can be
removed.
5.
the selector control knob back to the OFF position.
6.
Do not remove the
at any time during the brewing process
or until pressure is relieved.
7.
Use caution when removing the filter holder from the brew head. The
metal parts may still he very hot. Also, there may be hot water floating
metal parts may still he very hot. Also, there may be hot water floating
on the top of the filter basket
8.
If the filter hdder is blocked, allow the machine to cool down, then release
the steam with the instructions above. The blockage may be caused by too
finely ground coffee. See “Problems and Causes” on page 11.
9.
WHEN CLEANING THE FROTHING NOZZLE: Place a frothing pitcher or
large cup (with at least an 11 ounce capacity) half full of water under the
frothing aid. Make sure the tip of the frothing tube is
in liquid
before turning the selector control knob to the “steam”