Electrolux PE 9038-m fww ユーザーズマニュアル

This machine complies with  the directive BT 73/23 

Electrical safety rules EN 60335-1 (August 1995 - Safety for electrical household and 
similar appliances – General Standard) and EN 60335-2-15 (April 1996 – Specific Rules 
concerning the equipment for heating liquids). 
Directive EMC 89/336 in conformity with the following standards: 
- 

55014-1; 55014-2; 61000-3-2; 61000-3-3 

 
Any electrical work required to install this appliance should be carried out by a qualified 
electrician or competent person. 

 

Should the appliance power supply cable need to be replaced, this must be carried out 
by a Service Force agent. The manufacturer declines any liability should this safety 
measure not be observed. 
Before switching on, make sure the electricity supply voltage is the same as that 
indicated on the appliance’s rating plate. 
The appliance should be fitted with a 13amp plug. The plug should be fitted with a 
13amp ASTA approved BS1363/A fuse. The mains lead of the appliance should be 
connected as described below. The wires in the mains lead are coloured in accordance 
with the following code: 

 

• 

Green and Yellow - Earth 

• 

Blue - Neutral 

• 

Brown - Live  

 

In the plug the colours of the wires may not correspond with the markings identified 
with the terminals in your plug:  

1)  Connect the Green and Yellow (earth) wire to the terminal in the plug which is 

marked with the letter "E" or the earth symbol or coloured green and yellow.  

2)  Connect the Blue (neutral) wire to the terminal in the plug which is marked 

with the letter "N" or coloured black.  

3)  Connect the Brown (live) wire to the terminal in the plug which is marked with 

the letter "L" or coloured red. 

4)  Upon completion there must be no cut, or stray strands of wire present and 

the cord clamp must be secure over the outer sheath.