Bakers Pride ALF-FC ユーザーズマニュアル

ページ / 60
Automatic Lift Fryer 
 
Installation 
 
 
10 
Initial Test and Adjustment 
 
1.  Fill pot with shortening to about one inch below the mark.  
 
 
Risk of fire exists if the oil level drops below the minimum oil level. The level of oil 
within the pot must not fall below 5mm of the maximum oil level. 
 
Use of oil/shortening older than the manufacturers recommendations for life of 
the oil is prone to surge boiling and flash fires. Follow the oil manufacturers 
guidelines for lifecycle of oil/shortening. 
 
Overfilling the fryer pot with shortening could lead to serious injury. Ensure that 
the fryer pot is filled with shortening only to the fill mark when shortening is hot. 
Do not use any shortening other than what is specified in this manual and do not 
overfill the fryer pot. 
 
The fryer has a maximum temperature setting of 375º F/190º C (for ALF and 
ALF-F) or 390º F/200º C (for ALF-FC). Do not use oil/shortening with a flashpoint 
less than 554º F (290º C) 
 
Use only high-quality shortening that has low moisture content, a high smoke 
point and no additives. 
 
 
 
2. Place 
the 
FILTER/OFF/FRY switch to the FRY position. The shortening should begin to heat and 
begin to reach the fill mark inside the pot. Add more shortening as required to reach the fill mark. 
Refer to the troubleshooting section if this does not occur.