Mitsubishi Electronics sw1dnd-iqwk-e ユーザーズマニュアル
3 - 10
3.4.2 Creating module configuration diagrams
3 OPERATING PROCEDURE OF MELSOFT NAVIGATOR
iQ Works
(From the previous page)
6.
Select [Workspace]
⇒ [System
Configuration]
⇒ [New] ⇒ [Q Series
Module Configuration], and create a
new module configuration diagram.
new module configuration diagram.
7.
Change the module configuration name
to "Configuration diagram B" following
the same procedure in the step 1 and
step 2.
to "Configuration diagram B" following
the same procedure in the step 1 and
step 2.
8.
Select modules from the Module List
window, and drag and drop them onto
the base unit following the same
procedure in the step 3 and step 4.
window, and drag and drop them onto
the base unit following the same
procedure in the step 3 and step 4.
9.
Select the GOT unit (
) from
the Module List window, and drag and
drop it onto the Module Configuration
window.
drop it onto the Module Configuration
window.
10.
The message shown on the left is
displayed.
displayed.
Read the message and click the
button.
(To the next page)
Select
Drag & drop