Electrolux 9CHG584096 ユーザーズマニュアル

ページ / 19
OPERATING INSTRUCTIONS
Page 8
62.9585.01_UL
III . OPERATING INSTRUCTIONS
1.
GENERAL
The appliance is used for deep frying. In operation the basket 
is suspended.
The oil trough temperature is thermostatically controlled accor-
ding to the preset working temperature. An additional safety 
thermostat (STB) prevents unacceptably high temperatures 
from being reached.
In the case of appliances with two troughs, these can be used 
iAccessories supplied:
- frying baskets,
- basket rest grid,
- cover,
- outlet pipe.
Additional equipment:
- GN container,
- oil strainer
ndependently.
2.
OPERATION
2.1
MAINS SWITCH (1/Fig.11)
ON / OFF switch for the relevant fryer part.
When the appliance is switched on, the green operation lamp 
(2) lights up. The fryer in question is switched off when the 
rotary switch is at 0.
0 = 
Off
 
2.2
TEMPERATURE SELECTION
The temperature can be adjusted steplessly between 212°F 
and 356°F (100 and 180°C) via a thermostatic switch (3).
The white control lamp (4) goes out when the preset tempera-
ture is reached. The lamp lights up as long as the heating is 
switched on. The fryer is ready for operation when the lamp 
has switched off at least once.
2.3
PREPARATION
D
Raise fryer cover.
D
Remove basket from the oil.
D
Suspend it in the slots behind the hanger.
D
Fill with frying oil up to the (max. and min.) oil level mark.
Note
Observe max. and min. marking.
The oil filling capacity is 3.7 gal or 6.1 gal (14 or 23 litres) 
per container.
Animal or vegetable fats which are solid in the cold state 
are less suitable for the fryer.
The oil used must be replaced after each use.
If the oil level is too low, fryer performance drops and the 
oil gets overheated.
2.4
WORKING PROCESS
2.4.1
PREHEATING
D
Turn the mains switch (1) to position 
.
D
The green control lamp (2) lights up.
D
Turn the thermostat switch (3) to position 
.
D
Wait until the green control lamp (2) extinguishes.
2.4.2
DEEP FRYING
D
Turn the mains switch (1) to position 
I
.
D
The green control lamp (2) lights up.
D
Set the desired temperature on the thermostat switch (3).
D
The white operating light (4) lights up.
2.4.3
STANDBY
As soon as the white operating light (4) extinguishes (the ther-
mostat switches the heating off), the fryer is ready to load. If no 
food is placed in the oil, the heating switches on and off inter-
mittently. The white operating light (4) lights up periodically 
and extinguishes again.
3.
DEEP FRYING PROCEDURE
D
Submerge the food in the oil, i.e. place it on the supporting 
grid.
D
Shake the food to and fro.
After the deep frying process:
D
Lift the basket out.
D
Shake it.
D
Hang it in the suspension bracket to drain.
3.1
WORKING RULES
A large amount of food in the basket causes excessive 
cooling of the oil. At low temperatures the food absorbs 
fat and becomes unusable.
The maximum amount of food (pommes frites) to be fried is:
- for the 3.7 gal (14 lt.) trough1.5 kg
- for the 6.1 gal (23 lt.) trough 3 kg
3.1.1
TEMPERATURES
- When prefrying at 300°F (150°C) fill the basket to 2/3 
at most.
- For final frying at 356°F (180°C) fill the basket to 1/3 at 
most.
1
Mains switch
2
Green operating 
indicator
3
Thermostat
 
switch
4
White control
 
lamp
 Fig.11 Switch and operating indicator
Position to melt solid fat with reduced power 
 
rating.
Position for deep frying with full power.
Position for power off.
1
2
3
4
I
0
Food for deep frying
Temperature 
setting
°F
°C
Fish
338
170
Chicken thighs, frozen
338
170
Breaded cutlets
338
170
Pommes frites, frozen
556
180
Raw, preliminary frying
320
160
Ready fry
356
180