Henny Penny OE-100 ユーザーズマニュアル

The high temperature limit control is a manual reset control which
senses the temperature of the shortening. If the shortening temperature
exceeds the safe operating limit, this control will open and shut off the
heat to the frypot.

The high limit light will then illuminate and control must manually be
reset.

Disconnect the two wires from the high limit temperature control.
Check for continuity between the two terminals after resetting the
control. If the circuit is open, replace the control following these
procedures. If the circuit is closed, the high limit is not defective.
Reconnect the two electrical wires.

4. Unplug electrical wires from control panel board that are attached

to thermal sensor.

5. Using a 1/2" wrench, loosen screw nut from pot fitting and pull

thermal sensor bulb straight out from pot fitting.

6. Install new thermal sensor, making sure the thermal sensor ex-

tends through pot wall, up to the outer diameter of the heating
element.