Bunn TB6Q ユーザーズマニュアル

Page 14

FIG. 14-1 LIGHTED ON/OFF SWITCH

P/N 37080.0000

Orange light

FIG. 14-2 LIGHTED ON/OFF SWITCH TERMINALS

P/N 37080.0000

BLACK

2 WHT/VIO

WHITE

The ON/OFF switch is located in the front of the 

hood, above and to the left of the brew funnel.

Brewers W/Out Half Batch or Sweetener Options

1.  Disconnect the brewer from the power source.

2.  Remove the wires from all four terminals.

3.  Check for continuity across the two terminals on 

the lower right of the switch (as shown). Continuity 

must be present across these terminals in the ON 

position.

If continuity is present as described, reconnect the 

wires, the switch is operating properly. If continuity 

is not present as described, replace the switch.

NOTE:  No  continuity  will  show  across  the  upper 

left terminals of the lighted switch since the light is 

neon.

1.  Remove the wires from the switch terminals.

2.  Compress  the  clips  inside  the  hood  and  gently 

push the switch through the opening.

3.  Push the new switch into the opening and spread 

the clips to hold the switch captive in the hood.

4.  Refer to FIG. 14-2 when reconnecting the wires.

WHT/VIO

41722 070209