Electrolux D77000GF ユーザーズマニュアル

  42 

 
This appliance is designed to be installed with an 
appliance flexible connection only.  Supply piping 
should not be less than R

3

/8.  Connection is made to 

the Rc ½ (½” B.S.P.) female threaded entry pipe 
located just below the hotplate level on the rear left 
hand side of the appliance.  

Carry out a gas tightness test after connecting 

to the gas supply.  The gas bayonet connector must 
be fitted in the shaded area indicated in Fig.4.  Take 
into account that it must be possible to pull the 
appliance forward sufficiently.  Ensure the hose does 
not become trapped when pushing the appliance into 
position. 

 
 
 
 

It is recommended that if the appliance is to be 
installed with a flexible supply pipe, a stability chain 
be fitted and is available from your supplier (see 
Important Safety Requirements).  These instructions 
should be read in conjunction with any leaflet packed 
with the stability chain. 

 

1.  Place the appliance in its intended position and 

level appliance. 

2.  Mark a position 100mm from the top of the rear 

right hand corner. 

3.  Measure down 150mm from this point.  This gives 

the position of the wall anchor point for the 
stability chain. 

4.  The stability chain anchor point on the appliance 

is shown in the diagram Fig. 5. 

 

 
 
 

 

1.  The Triple crown injector is used as a pressure 

test point. 

2.  Connect the pressure gauge to the Triple crown 

injector. 

3.  Check the supply pressure by turning the Triple 

crown burner on and one other hotplate burner 
full on and light the appropriate burner.  The 
pressure should be 20mbar 

4.  Turn off the taps, disconnect the pressure gauge. 

5.  Check operation of each hotplate burner. 

 

 

 

 

 

 

 

Fig.5. 

Fig.4.