Electrolux 318205134 ユーザーズマニュアル

Before cleaning any part of the appliance, be sure all controls are turned OFF and the appliance is COOL.

REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS WILL

REDUCE THE NUMBER OF MAjOR CLEANINGS LATER.

Body Parts and Decorative

Trim

for general cleaning, use hot, soapy water and a cloth. For more difficult soils 

and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil 

for 30 to 60 minutes. Rinse with a damp cloth and dry. 

DO NOT use abrasive 

cleaners on any of these materials; they can scratch.

before cleaning the control panel, turn all controls to OFF. Lightly spray the 

control panel with a liquid cleaner. Wipe with a soft cloth or paper towel. DO

NOT use abrasive cleaners or scouring pads. These can permanently damage 

the control panel surface.

Broiler Pan and Grid

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with

a 1:1 solution of clear water and ammonia. if necessary, cover difficult spots

with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean 

water and a damp cloth, and then scrub with a soap-filled scouring pad. Rinse

and wipe dry with a clean cloth. Remove all cleaners or the porcelain may 

become damaged during future heating.

Decorative Trim, Oven

Racks, Oven Racks 

Support

Clean with hot, soapy water and a dishcloth. Rinse with clean water and a 

cloth. Cover stubborn spots with an ammonia-soaked paper towel for 30 to 40 

minutes. Rinse. Cleaners made especially for stainless steel are recommended. 

Be sure to rinse the cleaners as bluish stains may occur during heating and

cannot be removed.

Oven racks and oven rack supports must be removed from the oven during 

the self-clean cycle for cleaning. If they are not removed, the self-clean cycle 

will not start. Clean them as described above.

To clean oven door, wash with hot, soapy water and a clean cloth. 

DO NOT 

immerse the door in water or clean the oven door gasket.

The oven gasket located on the inner frame of the door and visible when the 

door is opened is essential for a good seal. Care should be taken not to rub, 

damage or remove the gasket.