Makita BHR242 (LXRH01*1) ユーザーズマニュアル

P 25/ 25

DX01, DX02

Red mark

Black lead wire

Connector viewed from lead wire installation side

Lead wires between Connector and Controller have to fixed 

with these lead wire holders. Do not slack them between

the lead wire holders.

Connector

Red lead wire

White lead wire

DC motor

Connect Lead wires to DC motor with 

Flag receptacles as drawn below.

Connect Lead wires to Connector with 

Flag receptacles as drawn below.

Black 

Lead wire

Red

Lead wire

Pass Lead wires through the holes of 

Line filter one by one and place them 

in the space between Ribs.

(Line filter is not used for some countries.) 

Pass Lead wires through the hole of 

Line filter and place them here.

(Line filter is not used for some countries.) 

DC motor

Put Lead wires between Connector and Controller into this groove.

Put Lead wires between Connector and Controller into this groove.

Put Lead wires between Connector and Controller into this groove.

Connector

Set DC motor in place so that the red mark

faces to the bottom of DX01/ DX02.