Jenn-Air LI3UUB ユーザーズマニュアル

8. Seal connections with vent clamps.

9. Plug 3 prong power cord into a grounded 3 prong outlet 

located above the range hood.

When using both upper and lower vent covers, push lower cover 
down onto hood and lift upper cover to ceiling and install with 
two 2.9 x 6.5 mm screws.

NOTE: For vented installations, the upper vent cover may be 
reversed to hide slots.

1. For non-vented (recirculating) installations only, install 

charcoal filters over grille on blower housing. See the “Range 
Hood Care” section.

2. Install metal filters. See the “Range Hood Care” section.

3. Check the operation of the range hood blower and light. See 

the “Range Hood Use” section.

NOTE: To get the most efficient use from your new range hood, 
read the “Range Hood Use” section.

The range hood is designed to remove smoke, cooking vapors 
and odors from the cooktop area. For best results, start the hood 
before cooking and allow it to operate several minutes after the 
cooking is complete to clear all smoke and odors from the 
kitchen.

The range hood controls are located on the front side of the 
canopy.

The range hood controls are located on the front side of the 
canopy.

After 30 hours of fan function, the display will show “Clean 
Grease Filter” when the fan is active. When this icon shows in the 
display, the installed grease filters should be washed. See 
“Range Hood Care” section.

■

To reset the grease filter saturation alarm, press and hold the 
POWER INCREASE button for 5 seconds. The “Clean Grease 
Filter” icon will no longer be displayed.

A

B

C

C

D

A

B

C

D

E