Philips V200 ユーザーズマニュアル
REF 1057983 A
Respironics V200 Ventilator Operator’s Manual
Appendix C-1
Appendix C. Alarm Testing Procedure
The following procedure is available if the operator wants to test the operation
of the following alarms. We recommend following “Preoperational Procedure”
on page 8-32 before performing the Alarm Testing procedure. It is assumed
that the preoperational procedure has been run before the Alarm Testing
Procedure is followed.
of the following alarms. We recommend following “Preoperational Procedure”
on page 8-32 before performing the Alarm Testing procedure. It is assumed
that the preoperational procedure has been run before the Alarm Testing
Procedure is followed.
Setup
1. Connect O
2
supply to the Respironics V200 Ventilator.
2. Connect optional O
2
sensor.
3. Run EST.
4. Attach the test lung to the patient wye. (Use the test lung provided
with your system.)
5. Use the following settings:
•
Mode VCV-A/C
•
Tidal Vol: 400ml
•
High Pressure (HIP): 50cmH
2
0 (hPa)
(or higher if required by the test lung)
•
Rate: 10 Bpm
•
Low Insp Press: 3 cmH
2
0 (hPa)
•
Peak Flow 40 Lpm
•
PEEP: 4 cmH
2
0 (hPa)
•
Low PEEP: 2 cmH
2
0 (hPa)
•
Low Vt Mand: 0 mL
•
PSV: 0 cmH
2
0 (hPa)
•
Low Vt Spont: 0 Lpm
•
I-Trigger: 2 cmH
2
0 (hPa)
•
High Rate: 150 Bpm
•
O
2
: 21%
•
Low VE: 1 L
•
Insp. Hold: 0 sec.
•
Apnea: 15 sec.
•
Apnea Rate: 20 Bpm