Viking DIPR151R ユーザーズマニュアル

5

The downdraft is shipped without a blower. Purchase a Model 

VIDV500 Interior  Blower and mount it to the downdraft as follows:

1.  Place the downdraft on its back on a table of flat work surface.

2.  Remove the 

4 nuts and 2 clamp channels.

3.  Remove 

2 screws and the gear motor cover.

4.  Carefully position the blower under the 

bottom flange of the 

downdraft with the 

3¼" x 10" discharge pointed in the desired 

direction.

5.  Connect 

motor plug.

6.  Replace the gear motor cover and 2 sheet metal screws.

7.  Replace the 2 clamp channels and start the 4 nuts, do not 

tighten.

8.  Slide blower left of right to desired position. Use

 cover plate 

(supplied) to close up any open space.

9.  Tighten 4 nuts to secure top of blower. Use 

additional screws 

(supplied) through bottom flange to secure bottom in blower.

NUTS

BLOWER

COVER 

PLATE

CLAMP 

CHANNELS

SCREWS

GEARMOTOR 

COVER

MOTOR 

PLUG

3¼" X 10" 

DISCHARGE

ADDITIONAL 

SCREWS

BOTTOM 

FLANGE

pLeaSe note: External blowers must be hard-wired using locally-

supplied wire and connected to the downdraft plug (included).

1.  The Interior Downdraft Blower system draws 4 AMPS and 

requires a 120 VAC, 60 Hz circuit.

2.  The downdraft has a 2 ft. long power cord with a 3-pronged 

plug. Plan to provide a grounded outlet in a location which will 

allow the unit’s power cord to reach.

 

If Model RDIPR101RSS is being installed in a 30" wide 

cabinet...

 

or Model RDIPR161RSS is being installed in a 36" wide 

cabinet...

   or Model RDIPR151RSS is being installed in a 45" wide 

cabinet...

 

    

 

In these cases, the width of the downdraft covers nearly the 

entire width of the back wall of the cabinet. So you must 

either:

•  mount the electrical box to a side wall or cabinet floor 

 

- at least 12 inches from the back wall.

•  mount  the  electrical  box  to  a  wall  stud  behind  the  

 

cabinet - where it will not be covered by the downdraft 

 

Then provide a clearance hole in the back wall of the  

 

cabinet.

 

 

1.  The Exterior Downdraft Blower system draws 6 AMPS and 

requires a 120 VAC, 60 Hz circuit.

2.  The downdraft has a 2 ft. long power cord with a 3-pronged 

plug. Plan to provide a grounded outlet in a location which will 

allow the unit’s power cord to reach.

 

If Model RDIPR101RSS is being installed in a 30" wide 

cabinet...

 

or Model RDIPR161RSS is being installed in a 36" wide 

cabinet...

 

or Model RDIPR151RSS is being installed in a 45" wide 

cabinet...

 

    

 

In these cases, the width of the downdraft covers nearly the 

entire width of the back wall of the cabinet. So you must 

either:

•  mount the electrical box to a side wall or cabinet floor 

 

- at least 12 inches from the back wall.

•  mount  the  electrical  box  to  a  wall  stud  behind  the  

 

cabinet - where it will not be covered by the downdraft 

 

Then provide a clearance hole in the back wall of the  

 

cabinet.