Dacor DHI542 ユーザーズマニュアル
5
p
lanninG
the
l
ocation
Carefully check the location where the hood is to be
•
installed. The hood should be placed for convenient
access. Make certain that electrical power can be
provided in the selected location.
Install the range hood and cooking appliance(s) so that
Install the range hood and cooking appliance(s) so that
•
they can be removed if service is required.
Plan the installation so that all minimum dimensions
Plan the installation so that all minimum dimensions
•
are met or exceeded (see page 3). Dimensions shown
provide minimum clearances, unless otherwise noted.
Preparing the Mounting Bracket Location
The mounting bracket must be attached directly to the
•
studs in the ceiling, or to a reinforced mounting block
secured to the studs. See below for mounting bracket
hole dimensions.
Attach the mounting bracket directly above the center
•
of the cooktop.
Attach the mounting bracket to the mounting surfaces
Attach the mounting bracket to the mounting surfaces
•
with #12 screws (not supplied). The screws must be of
sufficient length to penetrate into the wood mounting
surfaces at least 1 1/2” (3.8 cm).
The mounting surface must be level.
The mounting surface must be level.
•
Allow clearance in the center of the mounting bracket
•
for the exhaust duct to pass through the ceiling
(8-inches in diameter).
e
lectrical
p
ower
S
upply
Electrical Specifications
It is the owner’s responsibility to ensure that the electrical
connection of this appliance is performed by a qualified
electrician. The electrical installation, including minimum
supply wire size and grounding, must be in accordance with
the National Electric code ANSI/NFPA* (or latest revision)
and local codes and ordinances.
Connect the hood to a 120 Vac, 60 Hz dedicated,
Connect the hood to a 120 Vac, 60 Hz dedicated,
grounded, circuit protected by a 15 Amp circuit breaker or
time delay fuse.
*A copy of this standard may be obtained from:
National Fire Protection Association
*A copy of this standard may be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, Massachusetts 02269-9101
WARNING
The electrical service to the range hood should be
•
installed only by a licensed electrician.
Observe all governing codes and ordinances during
Observe all governing codes and ordinances during
•
planning and installation. Contact your local building
department for further information.
DO NOT
DO NOT
•
use the mounting anchors provided with the
unit. They are part of a standard mounting hardware
package provided with many Dacor hoods, but not
suitable for use with this model.
The range hood is heavy. To prevent personal injury
The range hood is heavy. To prevent personal injury
•
and property damage caused by the hood coming
loose from the ceiling, mount the hood mounting
bracket only as specified below.
p
reparing
for
i
nsTallaTion
12 9/16”
(31.9 cm)
6 1/8”
(15.6 cm)
11”
(27.9 cm)