ONKYO tx-nr646 ユーザーズマニュアル

Advanced Settings (Setup Menu)

Network Standby

Off

When this function is "On", you can turn on 

the power of the unit via network using an 

application such as Onkyo Remote.

● When "Network Standby" is used, the power 

consumption increases even when the unit 

is on standby. However, the increase in 

power consumption is kept to a minimum 

by automatically entering the HYBRID 

STANDBY mode, where only the essential 

circuit is operating.

Bluetooth Wakeup

Off

This function wakes up the unit on standby by 

connecting a Bluetooth-enabled device.

"On": Use this function

"Off": Do not use this function

● Setting to "On" increases the power 

consumption even when the unit is on 

standby. However, the increase in power 

consumption is kept to a minimum by 

automatically entering the HYBRID 

STANDBY mode, where only the essential 

circuit is operating.

● This setting is fixed to "Off" if "Bluetooth" - 

"Auto Input Change" is set to "Off".

● Wait for a while if "Network Standby" or "Bluetooth Wakeup" cannot be selected. It will appear when 

the network function is started up.

Make the network setting.

● When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the 

setting automatically. ("Enable" is set by default) To assign fixed IP addresses to each 

components, you must set "DHCP" to "Disable" and assign an address to this unit in 

"IP Address" as well as set information related to your LAN, such as Subnet Mask and 

Gateway.

Wi-Fi

Off (Wired)

Connect the unit to network via wireless LAN 

router.

"On": Wireless LAN connection

"Off (Wired)": Wired LAN connection

Wi-Fi Setup

–

You can configure wireless LAN settings by 

pressing ENTER when "Start" is displayed.

Wi-Fi Status

–

The information of the connected access point 

will be displayed.

"SSID": SSID of the connected access point.

"Signal": Signal strength of the connected access 

point.

"Status": Status of the connected access point.

MAC Address

–

This is the MAC address of the AV receiver.

This value is specific to the component and 

cannot be changed.

DHCP

Enable

"Enable": Auto configuration by DHCP

"Disable": Manual configuration without DHCP

● If selecting "Disable", you must set "IP 

Address", "Subnet Mask", "Gateway", and 

"DNS Server" manually.

IP Address

–

Displays/Sets the IP address.

Subnet Mask

–

Displays/Sets the subnet mask.

Gateway

–

Displays/Sets the gateway.

DNS Server

–

Displays/Sets the primary DNS server.

Proxy URL

–

Displays/Sets the proxy server URL.

Proxy Port

–

Displays/Sets the proxy server port number when 

you enter "Proxy URL".