Baldor EXB013A01 ユーザーズマニュアル
Section 4
Hardware Setup
Hardware Setup 4-1
DIP Switch Settings
This procedure will configure the Device Net Expansion Board for
communication with a computer or terminal. Reference Figure 4-1 and
Table 4-1 for the following procedure.
1.
communication with a computer or terminal. Reference Figure 4-1 and
Table 4-1 for the following procedure.
1.
Set DIP switches 1 and 2 for the desired baud rate.
2.
Set switches 3 through 8 for the ID number desired.
3.
Install the Device Net expansion board in the Series H control as
instructed in Section 3 of this manual.
instructed in Section 3 of this manual.
Note: The switch settings can be changed after the board is powered
up. However, switch changes will not take effect until the board
is reset (by pushing PB1 or by turning power off then on).
is reset (by pushing PB1 or by turning power off then on).
Cable Connection
1.
Connect the Device Net wires to the 5 pin connector provided with
the expansion board as shown in Figure 4-1.
the expansion board as shown in Figure 4-1.
Note: The Device Net bus must provide 24VDC power to the
expansion board.
2.
If a terminator is required, connect a 120 ohm terminating resistor
across pins 2 and 4 of the modular connector (CAN– and CAN+).
across pins 2 and 4 of the modular connector (CAN– and CAN+).
Powerup
When the Device Net expansion board is powered up it will perform the
following:
1.
following:
1.
Perform a self test.
2.
Check the switch settings for configuration information.
3.
Verify communications with the Series H control board.
4.
Check for power on the Device Net bus.
5.
Perform a Duplicate MAC ID check to determine if any other
devices on the network have the same MAC ID number.
devices on the network have the same MAC ID number.
6.
Go online.
After powerup, both LED’s should be GREEN.
Refer to the LED Indicators description in this section of the manual.
Refer to the LED Indicators description in this section of the manual.