Multiquip MVH-402DSB ユーザーズマニュアル

Figure 3 illustrates the location of the major components
for the MVH-402DSB  Reversible Plate Compactor. The
function of each component is described below:

1.

Hand Grip – When operating the compactor use this hand
grip to manuever  the compactor.

2.

Push the lever forward, the

compactor will move in a forward direction, 

pull the lever

backwards, the compactor will move in backwards direction.
Placing the lever in the middle (midway) will cause the
compactor not to move (neutral).

3.

Handle Bar – When operating the compactor, this handle
is to be in the downward position. When the compactor is
to be 

stored, move the handle bar to the upright  position.

4.

Guard Hook -  Used to lift the machine with crane or other
lifting device.

5.

Stopper -  Locks the handle in place in the upward postion
for stowing.

6.

Engine – This plate compactor uses a YANMAR L100EE-
DEVMK1 diesel engine. Refer to the owner’s manual for
engine information and related topics.

7.

Battery - Maintenance-free type requiring no electrode
replenishment.

8.

Belt Cover – Remove this cover to gain access to the V-
belts. NEVER run the compactor without the V-belt cover. If
the V-belt cover is not installed, the possibility exist that
your hand may get caught between the V-belt and clutch,
thus causing serious injury and bodily harm.

9.

Base Plate – Designed to compact sand, clay, and asphalt.

10. Oil Tank –  Fill with proper grade of diesel engine oil.

11. Vibration Case – Encloses the eccentric, gears and

counter weights.

12. Shock Absorber – Protects plate compactor from damage

by absorbing vibration during operation.

13. Throttle Lever – Controls the speed of the plate compactor.

Place straight vertically to start, push fully counterclockwise
for full trottle and fully clockwise to stop plate compactor.