Seagate ST31230DC ユーザーズマニュアル

Hawk 2LP (Wide) Installation Guide, Rev. A           31

continued from previous page

I/O pin 26 to the drive's internal termina-
tors (for single-ended I/O only).

Off

See above explanations for  TP jump
ers.

Drive ID on SCSI Bus (J1-auxiliary or J6

may be used, as the ID circuits are wired
in parallel). The drive ID is binary coded
positionwise i.e. jumper in position A

3

 is

drive ID 8, A

2

 is drive ID 4, position A

1

 is

ID 2, position A

0

 is ID 1 and no jumpers

is ID 0.  Default is ID = 0. Both J1-
auxiliary and J6 should not be used at
the same time, because at some future
time when the ID is changed the user
could fail to configure both J1-auxiliary
and J6 the same. "WC" and "DC" Mod-
els, do not have J1-auxiliary.

Drive ID on  SCSI  bus. Either J6 or J1-
Auxiliary  (optional)  may be  used  to
select drive ID. Both should not be used
at the same time, because at some