Seagate ST3620N/ND/NC ユーザーズマニュアル

30          Hawk 1LP Family Installation Guide, Rev. D

continued from previous page

TP Position A ("N" family models only)
On

This horizontally positioned jumper across the
two  TP positions nearest PCB edge, connects
terminator power from SCSI bus I/O pin 26 to the
drive's internal terminators.

Off

See above explanations for TP jumpers.

Drive ID on SCSI Bus (J6 may be used in-
stead). The drive ID is binary coded positionwise
i.e., jumper in position A

2

 is drive ID 4, in

position A

1

 is ID 2, position A

0

 

is  ID 1 and no

jumpers is ID 0. Default is ID = 0.

Drive ID on SCSI bus. Either J5 or J6 (optional)
may be used to select drive ID. Both should not
be used at the same time, because at some
future time when the ID is changed the user
could fail to configure both J5 and  J6 the same.
Default  is ID = 0. "NC" models can select drive
ID via the 80 pin SCSI I/O connector.