Smeg 142468 ユーザーズマニュアル

142468

Required tools; socket spanner nr. 8, 
screwdriver, torx 25.
Caution! After unscrewing of before fi xing hinges, 
hold the door to prevent it from falling and 
damaging.
1. Remove upper hinge cover (save it for eventual 

later use), remove also the cover on the opposite 
side of the upper hinge cover (on the opposite 
side you will insert the attached cover during the 
assembly), and remove the cover on the opposite 
side of the upper part of the door.

2. Unscrew upper hinge screws and remove the 

upper door from the middle hinge.

3. On the bottom side of the upper door unscrew the 

swing stopper screws and remove the stopper 
(A). Keep this for eventual use later on. Fix the 
attached stopper with its bearing on the opposite 
side of the door.

4. Unscrew the forced door closure system (B) 

and fi x it to the opposite side of the door (certain 
models only).

5. Unscrew middle hinge screws, remove the door  

from bottom hinge.

6. Unscrew leg holder fi xing screws.
7. Tilt the appliance backward (max. 35°) to lean 

to the rear side of the cabinet. Unscrew the 
leg support screws (C) - left and right, and 
remove the leg support cover (D) and place it to 
the opposite side. Unscrew and remove, then 
reciprocally replace the position of end switch (E) 
and decorative peg (F) (for models with forced 
door closing system). Unscrew three screws 
fi xing the bottom hinge (save the hinge for later 
use), and fi x the attached bottom hinge on the 
opposite side.

8. Repeat the procedure 3 and 4 on the bottom 

door. In case there is no bottom door limit peg, 
transfer the bearing (G) and washer to the 
opposite side of the door.  

9