Fellowes WB 100 ユーザーズマニュアル

1.  Punching/Crimping Handle
2.  Punching Area
3.  Adjustable Margin Guide
4.  Wire Size Selector
5.  Paper Support
6.  Binding Support
7.  Crimping Area
8.  Crimping Area Adjustor Dial
9.  Waste Paper Tray
10. Crimping Area Size Indicator

To assemble your WB 100 Wire Binding Machine,
simply attach the Punching Handle to the right side of
the machine and secure with the screw supplied.
Next, attach Paper Support in Crimping Area as show
in the diagram.

1. Holes should always be centered between the top

and the bottom of paper edge. To center holes, set
the adjustable margin guide on the left-side of the
machine for oversized covers (8-3/4" x 11-1/4")
or letter size documents (8-1/2" x 11"). For
optimum results, first use several “practice sheets”
to set up margin guide position.

2. Slide all sheets to the back of the punching area.

Note: a maximum of 8 sheets can be
punched at a time.

3. Lower the handle to punch holes in paper.
4. Return handle to its original vertical position and

remove sheets.

5. Repeat until all sheets and covers have been

punched.

The WB 100 Binding Machine has a built-in Wire Size
Selector to simplify the binding process.  To determine
correct size, insert entire document to be bound under
Wire Size Selector.  Move Selector downward until the
bottom portion touches document.  Read the
corresponding Wire Size on the Selector.

1.  Move the Crimping Area Adjustor to the correct

position so it corresponds with the appropriate
Wire Size according to the Wire Size Selector.

2.  Place wire on binding support hooks with open

side facing upward. Slide plastic guide strip above
hooks to the right to lock wire binding in place.

3.  Insert the punched sheets onto the wire binding.

NOTE:  For a correctly bound presentation, the
opening of the binding should be placed between
the last page and back cover of the document.

4.  Slide plastic guide strip to the left, back to its

original starting position, and remove entire
presentation.  

5.  Holding document in a vertical position, carefully

insert wire binding element into the Crimping
Area.

NOTE:  Wire Binding element should be in an
inverted "U" position.

6.  To secure document, crimp Wire Binding element

by lowering the Punching\Crimping Handle.

7.  Return handle to its original vertical position and

remove document.

To remove, simply slide the waste paper tray out
from the right side of the machine.
To prevent clogging and jamming, be sure to empty
waste paper tray frequently.

1

2

10

3

5

7

4

6

9

8