Dacor DYF428IWS ユーザーズマニュアル

Unpack Refrigerator

 

ƒ If you receive a damaged product, immediately contact your 

dealer or builder. Do not install or use a damaged appliance.

 

ƒ Do not remove the film on the outside until the refrigerator is in 

its operating position.

 

ƒ All four leveling legs must contact the floor to support and 

stabilize the full weight of the refrigerator.

 

ƒ Keep the cardboard shipping piece or plywood under the 

refrigerator until it is installed in the operating position.

1.  Remove and save the literature package bag taped to the side 

of the refrigerator and the parts bag behind the grille. Remove 
the four brackets (two on each side) that attach the shipping 
base to the refrigerator bottom.

NOTE: Do not remove tape and door bracing until the 
refrigerator is in its final position.

2.  If necessary, reduce the tipping radius. See Tipping Radius for 

ceiling height requirements or Reduce Tipping Radius for step-
by-step instructions. If you do not need to reduce the tipping 
radius, proceed to Move the Refrigerator into House.

Reduce Tipping Radius

(if required)

Before bringing the refrigerator into the home, be sure there is 
adequate ceiling height to stand the refrigerator upright. See 
Tipping Radius. 

If you do not have adequate ceiling height to stand the refrigerator 
upright, the tipping radius can be reduced by removing the top 
grille and side trims (see the following chart).

DYF42BIWS

88½” (224.8 cm)

DYF48BIWS

89¼” (226.7 cm)

Installation Instructions

1.  Grasp both ends of the top grille.

2.  Push the top grille straight up, then pull straight out. Lay the 

grille on a soft surface.

3.  Remove the six screws attaching each cabinet side trim to the 

refrigerator and remove the side trims.

Move the Refrigerator into House

1.  Place an appliance dolly under the left side of the refrigerator 

as shown. Be sure to avoid damaging the side trims and 
handles. Place the corner posts from the packing materials 
over the trims and handles as appropriate. Slowly tighten the 
strap.

2.  Place pieces of the shipping carton 

on the floor when rolling the dolly 
and refrigerator into the house. 
Move the refrigerator close to the 
built-in opening.

3.  Place top of cardboard carton or 

plywood under the refrigerator.

4.  Stand the refrigerator up. First, 

place the left bottom edge of the 
refrigerator on the floor, stand 
the refrigerator upright and then 
lower the right-hand side of the 
refrigerator to the floor. 

5.  Reassemble the trim and top grille after the dolly has been 

removed from the refrigerator.