Dacor DYF428IWS ユーザーズマニュアル

Location Requirements

Your Dacor refrigerator can be recessed in an opening between 
cabinets or installed at the end of a cabinet run using a side panel 
to enclose the refrigerator.

 

ƒ Observe all governing codes and ordinances.

 

ƒ It is recommended that you do not install the refrigerator near 

an oven, radiator, or other heat source.

 

ƒ Do not install in a location where the temperature will fall 

below 55°F (13°C).

 

ƒ The floor must support the refrigerator weight, more than 600 

lbs (272 kg), door panels and contents of the refrigerator.

 

ƒ The ceiling height must allow for side tipping radius. See 

Tipping Radius.

 

ƒ The location should permit doors to open fully. See Door 

Swing Dimensions.

 

ƒ The location must permit top grille removal. See Opening 

Dimensions.

Opening Dimensions

 

ƒ To avoid tipping during use, the solid soffit must be within 1” 

(2.5 cm) maximum above the refrigerator. If the solid soffit 
is higher than 1” (2.5 cm) or one is not available, then the 
refrigerator must be braced. 

 

If the anti-tip boards are needed, they must be attached to the 
rear wall studs 80” to 90” (203.2 cm to 228.6 cm) above the 
floor. See Install Anti-Tip Boards for more information. 

 

: A clearance of ¹⁄

2

” (1.3 cm) must be maintained above 

the top grille in order for the top grille to be removed.

Tools and Parts

 

ƒ Installer: Leave these installation instructions with the 

homeowner.

 

ƒ Homeowner: Keep these installation instructions for future 

reference. Save them for the local electrical inspector’s use.

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

 

ƒ Cordless drill

 

ƒ Drill bits

 

ƒ Two adjustable wrenches

 

ƒ Phillips screwdriver

 

ƒ Small level

 

ƒ Appliance dolly

 

ƒ Torx

 

®† 

 T27 screwdrivers

 

ƒ

¹¹⁄

32

” nut driver

 

ƒ

³⁄

8

” and ¹⁄

2

” open-end wrenches

 

ƒ Hex key (

5

⁄

32

”)

 

ƒ

¹⁄

4

” and 

5

/

16

” socket drivers

 

ƒ Tape measure

 

ƒ Utility knife

 

ƒ Six #8 x 3” (7.6 cm) wood screws (longer screws may be 

needed)

 

ƒ One or two 2” x 4” x 32” (5.1 cm x 10.2 cm x 81.3 cm) wood 

board(s)

 

ƒ Minimum 7 ft (2.1 m) flexible codes approved water supply 

line.

 

ƒ Dacor handle kit.

 

- ARFMH42H2: Millennia handle kit

 

- AFEBI42H2: Epicure handle kit

Installation Requirements

†

 

Torx

 

®

 is a registered trademark of Saturn Fasteners Inc.

¹⁄

2

” (1.3 cm)