3D Connexion LST42B ユーザーズマニュアル

25

Read this owner's manual and safety rules before operating your snow thrower.
Compare the illustration below with your snow thrower to familiarize yourself with the various controls and their locations.

CHUTE TILT HANDLE  Pivots the Upper Chute up or     
down  to control the angle and distance of discharge.
CRANK ROD  Rotates the Lower and Upper Chutes to
  control the direction of discharge.
LIFT HANDLE  Used to lift or lower the snow thrower
  to transport or operating position.
LIFT RELEASE TRIGGER  Releases the lock which
  holds the snow thrower in the transport position

UPPER AND LOWER DISCHARGE CHUTE  Controls
  direction and height of snow discharge.
SCRAPER PLATE  Replaceable plate that absorbs
  wear and impact from contact with ground. 
SKID SHOE  Controls amount of clearance between 
  the scraper plate and the ground.
SPIRAL AUGER, R.H. & L.H.  Feed snow to the
  impeller fan at the center of the housing.

•  Use the end of assembly checklist to verify that all 

instructions have been properly completed.

•  Make sure the skid shoes are adjusted to maintain 

adequate ground clearance between the snow 
thrower and the type of surface to be cleared. (Refer 
to the Service and Adjustments section.)

•  Make sure the tractor engine has the correct oil 

for winter operation (SAE 5W-30). Refer to tractor 
owner's manual.

•

The tractor should be sitting with the engine running 
at full throttle. Move the attachment clutch to the 
engaged position, starting the snow thrower before 
the tractor clutch is engaged.

•  To stop the snow thrower, disengage the tractor's 

attachment clutch lever for manual clutches or the 
clutch switch for electric clutches. Refer to your tractor 
owner's manual.

:   Never direct discharge 

towards bystanders or windows. Do not 
allow anyone in front of unit.

CONTROLLING SNOW DISCHARGE 
•  To control the direction snow is thrown, the discharge 

chute has 180 degrees of rotation. Turn the crank rod 
clockwise to rotate the chute to the right. Turn the 
crank rod counterclockwise to rotate the chute to the 
left.

•  To control the distance snow is thrown, the upper 

section of the discharge chute pivots up and down. 
Push forward on the chute tilt handle to pivot the 
chute down, decreasing the distance snow is thrown. 
Pull back on the handle to pivot the chute up, 
increasing the distance snow is thrown.