3D Connexion LST42B ユーザーズマニュアル

7

•  Remove all parts and hardware packages from the 

carton. Lay out parts and hardware and identify using 
the illustrations on pages 4 and 6.

NOTE:  Not all of the supplied parts and hardware will be 
needed for your particular tractor. Unneeded items may 
be discarded after you have completed assembly and 
checked operation of unit. 

DO NOT DISCARD the two 

spare shear bolts (N) and 5/16" nylock nuts (Y). Refer  to 
the Service and Adjustments section on page 27.

(2)  7/16" Wrenches
(2)  1/2" Wrenches
(2)  9/16" Wrenches
(2)  3/4" Wrenches
(1) Screw Driver
(1)  Knife 

ADDITIONAL ITEMS REQUIRED
General Purpose Grease

Before performing these instructions, refer to the Service 
and Adjustments section of your tractor owner's manual 
for specifi c safety instructions.

•  Allow engine, muffl er and exhaust defl ector to cool 

before beginning.

•  Remove any front or rear attachment which is 

mounted to your tractor.

•

Remove the mower deck. Refer to your tractor owner's 
manual for removal instructions. Mark all loose parts 
and save for reassembly.

•  Remove the tractor hood. Refer to your tractor owner's 

manual for removal instructions.

:  Before starting to assemble the 

snow thrower, remove the spark plug wire(s), 
set  the  parking  brake  and  remove  the  key 
from the tractor ignition. 

IMPORTANT: Right hand (R.H.) and left hand (L.H.) side 
of the tractor are determined from the operators position 
while seated on the tractor.

STEP 2:  (SEE FIGURE 2)
•  Remove the browning shield from the front of the 

tractor as shown. Hold onto the shield as you remove 
the second screw to prevent it from falling.

•  Be sure to reinstall the browning shield when so 

instructed in step 3.

STEP 1:  (SEE FIGURE 1)
• 

Look under the front of your tractor

Look

Look

. If there is a single 

mower deck suspension bracket located underneath 
the middle of the front axle, continue on to step 2. If 
your tractor does not have a mower deck suspension 
bracket underneath the middle of the front axle, 
skip to step 21 on page 13 for tractors with dual 
suspension brackets.