Frigidaire FGHN2844LE ユーザーズマニュアル

14

Inlet Valve
 1.  Disconnect refrigerator from electric power 

source.

 2.  Place end of water supply line into sink or 

bucket. Turn ON water supply and flush

supply line until water is clear. Turn OFF 

water supply at shutoff valve.

 3.  Remove plastic cap from water valve inlet 

and discard cap.

 4.  If you use copper tubing - Slide brass 

compression nut, then ferrule (sleeve) 

onto water supply line. Push water 

supply line into water valve inlet as far 

as it will go (¼ inch/6 mm). Slide ferrule 

(sleeve) into valve inlet and finger tighten

compression nut onto valve. Tighten 

another half turn with a wrench; DO NOT 

overtighten. See Figure 1.

    If you use stainless steel tubing - The nut 

and ferrule are already assembled on the 

tubing. Slide compression nut onto valve 

inlet and finger tighten compression nut

onto valve. Tighten another half turn with 

a wrench; DO NOT overtighten. See Figure 

2.

 5.  With steel clamp and screw, secure water 

supply line (copper tubing only) to rear 

panel of refrigerator as shown.

 6.  Coil excess water supply line (copper 

tubing only), about 2½ turns, behind 

refrigerator as shown and arrange coils so 

they do not vibrate or wear against any 

other surface.

  7.  Turn ON water supply at shutoff valve and 

tighten any connections that leak.

 8.  Reconnect refrigerator to electrical power 

source.

Steel

Clamp

Stainless

Steel

water line

Water Valve

Bracket

Valve Inlet

Water Valve

6 ft. Stainless Steel water line

from household water supply

Plastic Water Tubing

to Ice Maker

Fill Tube

Plastic Water

Tubing to Ice

Maker Fill

Tube

Steel

Clamp

Brass

Compression

Nut

Ferrule

(Sleeve)

Copper

water line

Water Valve

Bracket

Valve Inlet

Water Valve

Copper water line

from household

water supply

(Include enough tubing in loop

to allow moving refrigerator out

for cleaning.)